MIX Manual (split by node): Section: Back: 3.3.4 Assigning and Listing Devices Forward: 3.3.6 Breakpoints Chapter: FastBack: 3. mixsim – MIX Simulator. Up: 3.3 Terminal Mode and Debugger. FastForward: 4. mixrun Doc: Contents: Table of Contents Index: Concept Index   ?

3.3.5 Running a Program

GO
G
RUN
R

Emulates MIX GO button.

This command does the following:

  1. A single card is read into locations ‘0000--0015’;
  2. When the card has been completely read and the card reader is no longer busy, a JMP to location ‘0000’ occurs. The J-register is also set to 0.
This document was generated by Sergey Poznyakoff on October, 30 2009 using texi2html 1.78.

Verbatim copying and distribution of this entire article is permitted in any medium, provided this notice is preserved.